Repair Hyundai Getz

Hyundai Getz. The maintenance
+ 1. Operation and maintenance service
+ 2. The engine
+ 3. Transmission
+ 4. A running gear
- 5. A steering
   The general data
   Survey and steering check
   Steering column and steering shaft
   The steering mechanism
   Possible malfunctions of a steering with the hydraulic booster, their reasons and ways of elimination
+ 6. Brake system
+ 7. An electric equipment
+ 8. A body
9. Electric equipment schemes


864beb60



Hyundai Getz>> Steering>> Steering column and steering shaft
Cars without the  steering electroamplifier  

Fig. 5.11. A steering column and a steering shaft without the mechanism of adjustment of position of a steering wheel: 1 – the bottom shaft; 2 – a beam of the instrument panel; 3 – bolts of fastening of an arm of a steering shaft;
4 – the top facing casing of a steering column; 5 – the block подрулевых switches; 6 – a nut of fastening of a steering wheel; 7 – the bottom facing casing of a steering column; 8 – the antijoy ride device; 9 – the bottom facing of the instrument panel; 10 – a steering shaft; 11 – the steering mechanism


Fig. 5.12. A steering column and a steering shaft with the mechanism of adjustment of position of a steering wheel: 1 – the bottom shaft; 2 – a beam of the panel of devices;
3 – bolts of fastening of an arm of a steering shaft; 4 – the top facing casing of a steering column; 5 – the block подрулевых switches; 6 – a nut of fastening of a steering wheel; 7 – the bottom facing casing of a steering column; 8 – position of blocking of a clamp; 9 – the handle of a clamp of blocking of position of a steering wheel; 10 – position of an unblocking of a clamp; 11 – the bottom facing of the panel of devices; 12 – a steering shaft; 13 – the steering mechanism


The steering column and steering shaft without the mechanism of adjustment of position of a steering wheel are shown on fig. 5.11,  with the mechanism of adjustment of position of a steering wheel – on fig. 5.12.

Fig. 5.13. A steering column and a steering shaft of cars with the electroamplifier of a steering (rear view): 1 – facing of the switch of a sound signal (the module of a pillow of safety of the driver); 2 – a steering wheel; 3 – the electric motor; 4 – the electronic block of management


Fig. 5.14. A steering column and a steering shaft of cars with the electroamplifier of a steering (side view): 1 – the bottom shaft; 2 – the electronic block of management; 3 – a beam of the panel of devices; 4 – bolts of fastening of an arm of a steering shaft; 5 – the top facing casing of a steering column; 6 – the block подрулевых switches; 7 – a nut of fastening of a steering wheel; 8 – the bottom facing casing of a steering column; 9 – position of blocking of a clamp; 10 – the handle of a clamp of blocking of position of a steering wheel; 11 – position of an unblocking of a clamp; 12 – the bottom facing of the panel of devices; 13 – a steering shaft; 14 – the steering mechanism


The steering column and steering shaft of the cars equipped with the electroamplifier of a steering, are shown on fig. 5.13 and 5.14.
Removal
Disconnect "a minus" wire («–») from the storage battery.

Fig. 5.15. Bolts of fastening of the module of a pillow of safety of the driver


Remove the module of a pillow of safety of the driver, having turned away the bolts of fastening shown by arrows on fig. 5.15.

       THE NOTE
On the car without a safety pillow remove facing of the switch of a sound signal.

Fig. 5.16. A nut of fastening of a steering wheel


Turn away a nut of fastening of a steering wheel (fig. 5.16).

Fig. 5.17. Removal of a steering wheel from a shaft by means of a stripper


Combine labels on a shaft of a steering and a steering wheel. Remove a steering wheel from a shaft by means of a stripper (fig. 5.17).

       THE NOTE
Do not remove a steering wheel hammer blows – so it is possible to damage a steering shaft.

Fig. 5.18. Screws of fastening of a facing casing of a steering column


Remove a facing casing of a steering column, having turned away three screws shown by arrows on fig. 5.18.
Separate contact sockets of a contact disk of the module of a pillow of safety and the block подрулевых switches.

Fig. 5.19. Block removal подрулевых switches


Remove the block подрулевых switches, having pressed it in the places shown by arrows on fig. 5.19.

Fig. 5.20. Removal of the bottom facing of the panel of devices


Remove the bottom facing of the panel of devices, having turned away two bolts of fastening (fig. 5.20).

Fig. 5.21. Bolts of fastening of an arm of a shaft of a steering


Turn away four bolts of fastening of an arm of a shaft of a steering (fig. 5.21).

Fig. 5.22. A fastening bolt карданного the hinge to приводной to a gear wheel of the steering mechanism


Turn away a fastening bolt карданного the hinge to приводной to a gear wheel of the steering mechanism (fig. 5.22).

Fig. 5.23. Removal of a steering shaft in gathering


Remove a steering shaft in gathering (fig. 5.23).
Check of a technical condition
Check up a steering shaft on presence of damages and deformation.
Check up shaft connections on presence of backlashes, damages and on smoothness of moving.
Check up the ball bearing on presence of deterioration and damages.
Analysis and assemblage
In need of antijoy ride device removal make a chisel a groove under шлиц screw-drivers on heads of special bolts of fastening.

Fig. 5.24. Отворачивание bolts of fastening of the antijoy ride device


Screw-driver turn away two special bolts of fastening (fig. 5.24).
Remove the antijoy ride device from a steering shaft.

Fig. 5.25. A special bolt of fastening of the antijoy ride device to a steering shaft


At installation of the antijoy ride device acquire new special bolts kreple-nija the device to a steering shaft (fig. 5.25).
Tighten special bolts a wrench before cutting of heads.

Fig. 5.26. Bolts of fastening of the bottom shaft to knot of a steering column


Turn away fastening bolts (12 mm) bottom shaft to knot of a steering column and the top shaft (fig. 5.26).

Fig. 5.27. A detachment of the bottom shaft from knot of a steering column


Disconnect the bottom shaft from knot of a steering column and the top shaft of a steering (fig. 5.27).
Assemblage spend in an order, the return to dismantling.

Cars with the  steering electroamplifier  

Fig. 5.28. A contact socket of the electroamplifier of a steering


Separate a contact socket of the electroamplifier of a steering (fig. 5.28).

Fig. 5.29. Screws of fastening of the electroamplifier of a steering


Remove electroamplifier knot, having turned away three screws of fastening (fig. 5.29).
Assemblage spend in an order, the return to dismantling.
Installation
Establish into place a shaft of a steering and "acquire" four bolts of fastening.
Screw a fastening bolt карданного the shaft hinge to приводной to a gear wheel of the steering fur-nizma, located for a brake pedal.
Tighten four «наживленных» a bolt of fastening of a shaft of a steering.
Establish the bottom facing of the panel of devices and screw two bolts of fastening.
Establish on a steering column to защелкивания the block подрулевых switches.
Establish a contact disk of the module of a pillow of safety and connect a block socket подрулевых switches.
Establish the top and bottom facing casings of a steering column and screw fastening screws.
Establish a steering wheel and tighten a fastening nut.
Establish the module of a pillow of safety and wrap three bolts of fastening.
Attach "a minus" wire («–») to the storage battery.