Repair Hyundai Getz

Hyundai Getz. The maintenance
+ 1. Operation and maintenance service
- 2. The engine
   Technical characteristics of engines
   Specifications of engines
   Technical characteristics of engines in working volume of 1,5 and 1,6 l
   Specifications of engines in working volume of 1,5 and 1,6 l
   Technical characteristics of cars with engines in working volume 1,1
   Engines in working volume of 1,1 and 1,3 l
   Technical condition of the engine
   Broad-brush observations on repair of engines
   Removal and installation of the power unit
   The general sequence of dismantling of the engine
   Обкатка the engine after repair
   Engine check on the car after repair
   The block of cylinders
   Shatunno-piston group
   Cranked shaft and flywheel
   Head of the block of cylinders
   Camshaft and its drive
   Cooling system
   Greasing system
   The power supply system
   System of release of the fulfilled gases
   Possible malfunctions of the engine, their reason and ways of elimination
   Malfunctions of hydraulic pushers of valves
   Malfunctions of system of giving of fuel and ways of their elimination
+ 3. Transmission
+ 4. A running gear
+ 5. A steering
+ 6. Brake system
+ 7. An electric equipment
+ 8. A body
9. Electric equipment schemes


864beb60



Hyundai Getz>> The engine>> Обкатка the engine after repair
The repaired engine is exposed to bench tests (обкатке) without loading on a following cycle.
                            Frequency of rotation,
                             Mines-1                                   Time, mines
750Ц800.........................................2  
1000..............................................3
1500..............................................4
2000..............................................5

Having established the engine at the stand, start up it and check up:
— Absence of a leak of a cooling liquid or fuel between interfaced details and in connections of pipelines;
— Pressure of oil and absence подтекания oils through linings;
— Installation of the moment of ignition;
— Frequency of rotation idling;
— Tightness of connections of the power supply system in a motor compartment.
If extraneous knocks or malfunctions are found out, stop the engine, eliminate them, and then continue tests.
At подтекании oils through a lining between the pallet картера and the block of cylinders tighten fastening bolts the recommended moment. If the leak does not stop, check up a lining and if necessary replace it.
At подтекании oils through a lining between a cover of a head of the block of cylinders and a block head check up a lining and rubber заглушки on face surfaces of a head of the block of cylinders. If necessary replace a lining and заглушки, observing the recommendations stated in subsection «engine Assemblage».
After engine repair it is necessary to observe a certain mode of operation for the period extra earnings of working surfaces of new details. It especially concerns those engines with which pistons, loose leaves шатунных and radical bearings, перешлифованы necks of a cranked shaft, отхонингованы cylinders have been replaced.
Therefore during time обкатки the repaired engine on the car do not subject to its maximum loadings. Обкатка the engine it should be spent with observance of those speeds of movement and loadings which are recommended for the period обкатки the car.